Bulroc ODS 240

Eccentric Overburden Drilling System

Drilled Hole Diameter 12.2" -- Casing Size 10.75" O.D. x 10.24" I.D.

The ODS 240 is a two-part Eccentric Overburden Drilling System designed for the simultaneous installation of casings to support unstable ground conditions. The bit holder is fitted into the hammer in the same way as a conventional button bit would be. The Eccentric Button Bit is locked into the Bit Holder by means of a double "Seloc" pin arrangement that can be removed when the Bit needs either regrinding or replacing.

When the ODS 240 has been drilled to the required depth, the Eccentric Bit can be closed to its concentric position and the complete system withdrawn from the Casing. If required, it is then possible to drill on into solid rock using a Conventional Button Bit with a maximum diameter of 9.45". It is important to make sure that a stabilizer of the correct dimensions is positioned directly behind the hammer. On deep angled holes it is recommended that further stabilizers are positioned after 32.81 feet of drill tube.

Complete System: DHD380 and SD8.
A complete system comprises Bit Holder, Eccentric Bit, and Locking Pin.

Technical Specifications

		Component Parts
		Reference	Description
		1	Bit Holder DHD380
			Bit Holder SD8
		2	Locking Pin Set
		3	Eccentric Bit
		4	Casing Shoe
		5	Stabilizer
		Specifications
		Bit Holder O.D.	10.08"
		System Closed	9.5"
		System Open	12.2"
		Casing Size	10.75" O.D. x 10.24" I.D.
		Total System Weight	374 lbs.